[. . . ] –  ■ ■ The metal parts can be damaged if they are dropped. Lay a drop cloth on the floor to cushion the parts and cover the flooring. These instructions are intended as a general guide only and do not supersede any national or local codes in any way. [. . . ] Install the top trim mount (A) onto the top grille assembly (B) by sliding it onto the grille section at the top. Align the hole in the side trim piece (E and G) with the groove on the top grille (B) on each side of the grille assembly. Using the two countersunk Phillips screws (K) (provided), fasten the side trim piece (E and G) to the top grille assembly (B). Insert the screw through the predrilled hole and into the groove on each side of the top grille assembly (B) as shown. Align the side trim pieces (E, G) with the sides of the top grille assembly (B). NOTE: Make sure all the grille pieces are contained within the channel of the side trim pieces (E and G) and the top surface of the top grille (B) is flush with the top surface of the sides. INSTALLATION INSTRUCTIONS Install the Top Grille and Trim Assembly IMPORTANT: The top grille and trim assembly, and your floor can be damaged if the assembly is dropped. Use several pieces of tape to temporarily hold the assembly in place as shown. Place cardboard or hardboard over the floor at each side of the rough opening where the side trim will meet the floor. Place the refrigerator/freezer on its back on top of a piece of cardboard or other protective material. Move the First Appliance IMPORTANT: If the electrical outlets are not centered in the back wall of the opening, move the appliance on the opposite side of the outlets into the opening first. Attach a plastic foam rear spacer (I) to the rear center of both appliances. NOTE: The rear spacers (I) ensure that the 2 appliances are positioned the correct distance from the wall to avoid cabinet damage. Slide the first appliance into the opening far enough to connect the power cord to the electrical outlet. IMPORTANT: Wait 24 hours before plugging in your refrigerator or freezer to avoid compressor failure. Adjust the leveler legs (M) so that each appliance is level, plumb and at the same height as the other appliance. NOTE: Now, the freezer and refrigerator each have two front leveler legs (M) that are adjustable. Repeat Step 3 for the other appliance until both the freezer and refrigerator are level, plumb and at the same height. [. . . ] Do not depend on the door gasket magnets to hold the door in place while you are working. Insert one painted pan-head Torx®† screw (L) through the top plate (D) and thread it into the cabinet. Align the top plate (D) holes with the holes in the appliances and install the remaining three screws (L) as shown. [. . . ]